What's In The Box; Placement In The Laboratory; Ambient Laboratory Conditions - LI-COR C-DiGit User Manual

What's in the Box

In addition to the C-DiGit Blot Scanner, you will find the items shown below
(l-r): 1) Ethernet and 2) USB cables, 3) a power supply with interchangeable plugs,
4) a C-DiGit Target image, and 5) Image Studio and Resource CDs.
1
The C-DiGit Target (p/n 6536-030) is a photosensitive card used to verify that your
C-DiGit Blot Scanner is functioning properly; the card is briefly exposed to room
light and then imaged on the instrument. If the acquired pattern matches the target
image, the C-DiGit Blot Scanner is functioning as it should, and is ready to image
your sample. Instructions for using the Target are given below in Section 2, Quick
Start Tutorial. The Target should be stored in the blue envelope when not in use.
* Use only the provided cables with the C-DiGit Blot Scanner.

Placement in the Laboratory

The C-DiGit Blot Scanner weighs approximately 2.18 kg (4.8 lbs.). The instrument
should be placed on a level surface that is at a workable height for the user.

Ambient Laboratory Conditions

Place the C-DiGit Blot Scanner away from external heat sources (furnaces,
windows, etc.). Additional heating can cause high temperatures within the
enclosure. Place the instrument away from sinks or other sources of water that pose
a shock hazard. Recommended operating conditions are 15-30 °C and a dew point
no greater than 25 °C to prevent condensation on the instrument.
3
4
2
Introduction
5
C-DiGit User Manual
1
1-2