LI-COR D-DiGit Quick Start Manual

D-DiGit™ Gel Scanner Quick Start Guide

Unpack the D-DiGit Gel Scanner

Unpack the box and check for the components.
1. D-DiGit Gel Scanner
2. Power cords
Important: Be sure to use the correct
power cord for your country. If you need to
use a Safety Approved plug adapter, be
sure that the adapter is rated to
10Amp/250V. Do not use the US power
cord with a plug adapter.
3. Viewing shield
4. Power adapter
5. USB Cable
6. Quick start guide

Install D-DiGit Image Acquisition Software

You may need administrator rights on your computer to install software.
Note: Install the software before connecting the scanner to the computer.
1. Download the D-DiGit Image Acquisition Software from licor.com/ddigit-software.
2. Follow the installation instructions on the download page.

Unlock Scanner

1. Ensure the scanner is powered off, and the power cord
is unplugged.
2. With the rear panel of the scanner facing you, tilt the
scanner and locate the locking switch underneath the
scanner.
3. Push the locking switch to the left until the "unlocked"
icon is showing, as indicated in the graphic at right.

Connect Power and USB Cables

1. Connect the power adapter
Connect the power adapter to the back of the scanner. Plug one end of the power cord into the power adapter and the other end
into a wall outlet.
2. Connect the USB cable
Connect one end of the USB cable to your computer and the
other end to the scanner.
1
3
* Only the US power cord is shown.
When shipping the D-DiGit Gel Scanner, ensure the switch is in
the locked position. See the manual for directions
(licor.com/ddigit-manual).
2
2 *
4
5
Unlocked Locked
1