Page 1
D-DiGit® Gel Scanner Cleaning and Shipping Instructions This guide will show you how to clean and package the scanner for return to LI-COR. The included Quick Start guide will tell you how to set up and use the scanner. Before you begin, please note the following.
Page 2
D-DiGit® Gel Scanner Cleaning and Shipping Instructions - Page 2 Cleaning and Packaging Instructions Thank you for taking the opportunity to try out the D-DiGit Gel Scanner (model number 3500). Once you are finished testing, there are four steps to return the test scanner to LI-COR.
D-DiGit® Gel Scanner Cleaning and Shipping Instructions - Page 3 Care and Cleaning Note: To avoid contamination, fresh Kimwipes should be used to clean each section of the scanner (as described below). Note: Do not use any detergents, synthetic cleaning solutions, cleaning naptha, or other solvents to clean the scan surface.
D-DiGit® Gel Scanner Cleaning and Shipping Instructions - Page 4 Prepare Scanner for Shipment Lock the D-DiGit Gel Scanner before shipping it. 1. Ensure the scanner is powered off, and the power cord is unplugged. 2. With the rear panel of the scanner facing you, tilt the scanner and locate the locking switch underneath the scanner.
D-DiGit® Gel Scanner Cleaning and Shipping Instructions - Page 5 Packaging Procedure Please package the scanner according to these instructions before shipping it back to LI-COR. Important: Ensure the scanner is locked before continuing. Important: Do not return the SYBR® Safe Stain to LI-COR.
Page 6
D-DiGit® Gel Scanner Cleaning and Shipping Instructions - Page 6 3. Place bottom foam piece in box The bottom foam piece is the piece with semicircular cuts on the outer edge. Place the bottom foam piece in the box in the orientation shown.
Page 7
D-DiGit® Gel Scanner Cleaning and Shipping Instructions - Page 7 6. Bag cords and place them in the box Place the power cord(s) and USB cable in their bags, then place the cord(s) and USB cable around the edges of the box.
Page 8
D-DiGit® Gel Scanner Cleaning and Shipping Instructions - Page 8 a. Place the cardboard and Viewing shield in the box. 8. Add the last sheet of cardboard and close the box a. Place the remaining sheet of cardboard in the box on top of the Viewing shield.
Page 9
D-DiGit® Gel Scanner Cleaning and Shipping Instructions - Page 9 c. Securely close the box. d. Tape the lid of the box as it was taped when the box was received. Ensure the tape is secure, so the box will not come open...
Page 10
D-DiGit® Gel Scanner Cleaning and Shipping Instructions - Page 10...
Page 11
D-DiGit® Gel Scanner Cleaning and Shipping Instructions - Page 11...