LI-COR C-DiGit User Manual page 115

Windows XP Installation Instructions
7. Reboot your computer
Reboot your computer to activate the driver installation. NOTE: If you
disconnect the C-DiGit Blot Scanner from one USB port and reconnect it at a
different USB port, you must go through the driver installation process again
and reboot your computer to activate the driver installation.
8. Wait for network connection
Wait for the Local Area Connection system tray message to appear, as shown
below. Alternatively, you can check the network connection status in the
Control Panel->Network Connections as described at the end of this section,
'Still Can't Connect?'
Local Area Connection 3
Speed: 425.9 Mbps
Status: Limited or no connectivity
9. Start Image Studio
Double-click the Image Studio icon (below) on the desktop to start Image
Studio.
10. Create a New Work Area Folder
The first time you start the software you will need to create the first Work Area.
The Work Area is a folder on the hard drive or network where the images,
analyses and settings are stored.
Click Create New... in the Set Active Work Area dialog box to browse to a
folder on the hard drive or network to use as the Work Area.
Click the New Folder icon to create a new folder for the Work Area. Name the
folder; this folder will now appear in the Available Work Areas window each
C-DiGit User Manual
B
B-6