Network Configuration - Riso HC5500 Series User Manual

5.7 Network Configuration

If the printer is connected to a network and all the conditions shown below are satisfied, you can register the network configura-
tion. If the conditions below are not satisfied, you can check the settings.
• DHCP OFF
• IP address is "000.000.000.000"
To change the setting, use "Administrator" of RISO Console or supplied software "RISO IP Setting Tool."
The settings will be effective after the printer is restored from the sleep mode. For details, consult your network administrator.
~ ~ ~ ~ Settings
DHCP ON
DHCP OFF
1
Use steps 1 to 4 () ) ) ) p.2-31) to display
"Administration."
2
Press the
"Network Config."
3
Press the OK Key.
Set the DHCP.
4
Press the
or OFF.
5
Press the OK Key.
If you have selected ON, proceed to step 10.
Input the IP address.
2-44
The IP address, subnet mask, and default gateway are obtained from the DHCP server, and the settings
of the printer controller are automatically set and registered..
Set the following three items on the Operation Panel.
IP address Input the IP address of the printer.
Set the address in the range of "000.000.000.000" - "255.255.255.255."
Subnet mask Input the subnet mask address.
Set the address in the range of "000.000.000.000" - "255.255.255.255."
Default gateway Input the default gateway address.
Set the address in the range of "000.000.000.000" - "255.255.255.255."
or key to display
or key to select ON
6
Press the
sor. and press the
enter the value.
7
Press the OK Key.
Input the subnet mask address.
8
Press the
sor, and press the
enter the values.
9
Press the OK Key.
Input the default gateway address.
keys to move the cur-
keys to
keys to move the cur-
keys to