Others - Riso HC5500 Series User Manual

Others

Print speed is too low.
A paper jam occurs each time printing is
performed.
• There's too much paper powder.
• Double feed occurs.
• Thick paper such as postcard is mis-
fed.
• The back surface of thick paper such as
postcard is peeled off.
Paper is not fed at all.
3-20
Problem
The paper size is judged based upon the guide positions, and print speed depends on
specifications of paper size. Adjust the stack guides securely to the width of the
paper.
Too much paper is loaded in the Standard Feed Tray or other Feed Trays.
When the maximum number of sheets of paper that can be loaded in the Standard
Feed Tray or other Feed Trays is exceeded for the number of paper that can be
loaded. Please refer to "Loading Paper")p.1-10.
Paper is not loaded properly.
Check the Stack Guide positions. For proper paper loading, refer to "Loading
Paper")p.1-10.
Paper that cannot be used is loaded.
Check the paper types that can be loaded in the Standard Feed Tray and the other
Feed Trays. Do not use particularly wrinkled or curled paper because it may cause
a paper jam.
"Usable Paper")p.1-6
Non-standard size paper is used.
When loading non-standard size paper, you must register the size at "5.1 Paper
Size Entry" and "5.2 Paper Type Entry" of the menu setting in advance.
"5.1 Paper Size Entry")p.2-32
"5.2 Paper Type Entry")p.2-33
The paper stripper pressure is not properly adjusted.
Use a coin to turn the Paper Stripper Dial located in the paper feed side to adjust the
pressure.
The Paper Feed Pressure Adjustment Lever does not fit the paper thickness.
When using thick paper, set the Paper Feed Pressure Adjustment Lever to the
"
When printing onto paper other than thick paper, set the lever to the "
MAL)" position. If paper mis-feed occurs frequently, however, set the lever to the
"
"Paper Feed Pressure in Standard Paper Feed Tray")p.1-13
Paper feed control is not proper.
Change the paper feed control set in the Standard Feed Tray or other Feed Trays at
"5.2 Paper Type Entry" of the menu setting.
"5.2 Paper Type Entry")p.2-33
The guides in the Standard Feed Tray (Feed Tray) do not fit the paper width.
Before starting adjustment, be sure to remove the paper from the
Standard Feed Tray and check that the tray lowers to the lowermost
position.
• If there's too much paper powder, paper is
mis-fed or the back side of postcard curls
up, turn the dial counterclockwise.
• If double feed occurs, turn the dial clock-
wise.
(CARD)" position.
(CARD)" position.
Cause and Solution
(NOR-