Materials Not To Be Printed - Riso HC5500 Series User Manual

~ ~ ~ ~ Maximum Print Area (Image Area)
When an original is scanned through the optional scanner, printing can be performed into the area inside 1 mm (0.04") from
the sides of paper but deterioration of print quality such as loss of characters or figures and bleeding may occur depending on
the original.
Even if the paper size is larger than 316mm × 460mm (12
3 5
458mm (12 / " × 18 / ").
8 16
• "4.10 Image Area" of the menu setting must be set. "4.10 Image Area" )p.2-29
• Depending on the application, it may not be possible to make a margin of 1 mm (0.04
application software, margin width of 5 mm

Materials Not to Be Printed

Do not use the machine in any manner which violates the law or infringes on established copyrights, even when making copies
for personal use. Consult your local authorities for further details. In general, use discretion and common sense.
Power Connection
z z z z Connect the power plug securely to the electrical outlet to avoid improper connection.
z z z z Install the machine near the electrical outlet.
z z z z If an optional device is connected to an electrical outlet for option connection on the machine, the optional device is turned on
and off at the same time as the machine.
z z z z Use only the power cord supplied by the seller of the controller, or use a cord that is earthed, not longer than 4.5m, rated not
less than the controller is rated, and authorized by the state or region where it is used.
Sleep
When the machine is on and is not used for a certain time, the machine enters automatically the energy saving mode. Two types
of energy saving mode are provided: Stand-by mode and Sleep mode.
• Stand-by mode: Power consumption is 150 W or less.
When data is received from a computer, the machine enters the print mode.
To turn on the print mode from the operation panel of the printer, press the WAKE-UP Key.
• Sleep mode: Power consumption is 200 W or less.
To enable reception of data, perform startup operation from a computer.
To start up from the operation panel of the printer, press the Sleep Key.
The energy saving function is set in "Menu 5 Administration" on the operation panel.
If the machine is not used for a long time, turn off the Main Power Switch and remove the power plug from the electrical outlet.
(When the Main Power Switch is turned off, the power consumption becomes 0 W.)
7 1
/ " × 18 / "), the actual maximum printable area is 314mm ×
16 8
3
( / ")
is required.)
16
"
) width along the edges of paper. (In most
ix