Table of Contents
Advertisement
5.7 Network Configuration
If the printer is connected to a network, register the IP address, subnet mask, and default gateway. The settings will be effective
after the power is turned off and then on again. For details, consult your network administrator.
" " " " Settings
DHCP ON
The settings of the IP address, subnet mask, and default gateway of the printer controller are used and
registered.
DHCP OFF
Set the following three items on the Operation Panel.
IP address
Subnet mask
Default gateway
1
Use steps 1 to 4 (# # # # p.2-31) to display
"Administration."
2
Press the
or
"Network Config."
3
Press the OK Key.
Set the DHCP.
4
Press the
or
or OFF.
5
Press the OK Key.
If you have selected ON, proceed to step 10.
Input the IP address.
Input the IP address of the printer.
Set the address in the range of "000.000.000.000" - "255.255.255.255."
Input the subnet mask address.
Set the address in the range of "000.000.000.000" - "255.255.255.255."
Input the default gateway address.
Set the address in the range of "000.000.000.000" - "255.255.255.255."
key to display
key to select ON
6
Press the
sor. and press the
enter the value.
7
Press the OK Key.
Input the subnet mask address.
8
Press the
sor, and press the
enter the values.
9
Press the OK Key.
Input the default gateway address.
10
Press the
sor, and press the
enter the values.
keys to move the cur-
keys to
keys to move the cur-
keys to
keys to move the cur-
keys to
2
2-43
Advertisement
Table of Contents
