Network Configuration - Riso HC5000T Instruction Manual

fm.book 61 ページ ２００４年７月１３日 火曜日 午後４時５５分

5.7 Network Configuration

If the printer is connected to a network, register the IP address, subnet mask, and default gateway. The settings will be effective
after the power is turned off and then on again. For details, consult your network administrator.
Settings
DHCP ON The settings of the IP address, subnet mask, and default gateway of the printer controller are used and
registered.
DHCP OFF Set the following three items on the Operation Panel.
IP address
Subnet mask
Default gateway
1
Use steps 1 - 4 ( p.49) to display
"Administration."
2
Press the or
"Network Config."
3
Press the OK Key.
Set the DHCP.
4
Press the or
or OFF.
5
Press the OK Key.
If you have selected ON, proceed to step 10.
Input the IP address.
Input the IP address of the printer.
Set the address in the range of "000.000.000.000" - "255.255.255.255."
Input the subnet mask address.
Set the address in the range of "000.000.000.000" - "255.255.255.255."
Input the default gateway address.
Set the address in the range of "000.000.000.000" - "255.255.255.255."
6
key to display
7
Input the subnet mask address.
8
key to select ON
9
Input the default gateway address.
10
Press the keys to move the cur-
sor. and press the
enter the value.
Press the OK Key.
Press the keys to move the cur-
sor, and press the
enter the values.
Press the OK Key.
Press the keys to move the cur-
sor, and press the
enter the values.
2
keys to
keys to
keys to
61