Bearing Replacement - Honda CH250 Elite 1986 Service Manual

STEERING/FRONT WHEEL/BRAKE/SUSPENSION
BEARING REPLACEMENT
Remove the side collar and dust seal.
Install the bearing remover head into the bearing.
From the opposite side install the bearing remover shaft and
drive the out of the wheel.
Remove the spacer and drive out other bearing.
NOTE
• If the
hAJ. .
i,,,,,,
are removed, they must be re~,la(;ed with
new ones.
(1 )
ATTACHMENT, 32 x 35 mm
07746-0010100
PILOT, 12 mm
7746-0040200
Do not allow the tilt while driving
• Drive in with the sealed side facing
• Never reinstall
an
bearing, once a bearing is r.en,nv'Arl.
must be with a new one.
NOTE
the cavities with grease.
the left bearing in squarely, until its seated.
Install the spacer and drive the right bearing in squarely, until
its seated.
dust seal.
14-7