Table of Contents
Advertisement
VALVE CLEARANCE
NOTE
Inspect and adjust valve clearance while the
(below 35"C/95"F).
Remove the left rear covers (page 13-2).
Remol/e the frame left side raiL
13-31.
Remol/e the left crankcase cover
8-3).
Remove the ins,pection hole cap from the left side of the cylin-
der head.
Remove the left crankcase cOl/er (page 8-3).
Rotate the drive pulley counterclockwise and align the "T"
mark on the camshaft with the index mark on the cylinder head
cover to bring the piston to TDC
Dead Center) on the
compression stroke.
Loosen the valve adjuster lock bolts, which are located on the
left side of the cylinder head.
Move the intake and exhaust adjusters outward (away from
each
otherl
untill resistance is felt.
Then move them inward (toward each other) one grElduatllon.
the lock bolts.
NOTE
• One graduation
on the adjusters
0.10 mm (0.004
in), which is the
value clearance.
Install the removed parts in the reverse order of removal.
MAINTENANCE
3-7
Advertisement
Table of Contents
Troubleshooting
