Electrical - BOMBARDIER Quest Max 2004 Operator's Manual

Pour air filter cleaning solution (P/N 293
600 059 or an equivalent) into a bucket.
Put the filter in to soak.
While filter soaks, clean inside the air
box.
Rinse the filter with warm water until
all cleaning solution disappears.
NOTE: If the air filter foam is still dirty,
replace it with a new one.
Then, let the filter dry completely.
When the filter is dried, re-oil with air
filter oil (P/N 293 600 058 or an equiv-
alent).
Air Filter Installation
Properly reinstall removed parts in the
reverse order of their removal.

Electrical

Battery
Quest MAX and Traxter MAX Series
WARNING
Never charge a battery while in-
stalled in vehicle.
Removal
Disconnect BLACK (-) cable first then
RED (+) cable.
WARNING
Always respect this order for dis-
assembly; disconnect BLACK (-)
cable first. Electrolyte or fuel va-
pors can be present in engine
compartment and a spark may ig-
nite them and possibly cause per-
sonal injuries.
Remove the holding straps.
Pull out vent tube from frame.
Remove battery from vehicle being
careful not to tilt it so that electrolyte
flows out of vent tube.
132
WARNING
Battery electrolyte is a caustic sub-
stance that burns or destroys or-
ganic tissues by chemical action.
Avoid contact with eyes, skin and
clothing. Wear protective eye-
glasses and a suitable pair of non-
absorbent gloves when removing
the battery by hand. Should any
electrolyte spillage occur, imme-
diately wash off with a solution of
baking soda and water.
Cleaning
Clean battery, battery casing, cables
and battery posts using a solution of
baking soda and water.
Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush. Battery top should be
cleaned by soft brush and any grease-
cutting soap or baking soda solution.
Refilling
Place battery on a level surface.
Unscrew caps and add distilled water
up to upper mark as required. Do not
overfill.
V00G02Y
1. Upper mark
Properly retighten caps.
1