Steering System - BOMBARDIER Quest Max 2004 Operator's Manual

Check pressure when tires are "cold"
before using the vehicle. Tire pressure
changes with temperature and alti-
tude. Recheck pressure if one of these
conditions has changed.
For your convenience, a pressure gauge
is supplied in tool box.
TIRE PRESSURE
QUEST MAX SERIES
MAX.
UP TO
272 KG
(600 LB)
MIN.
TRAXTER MAX SERIES
MAX.
UP TO
290 KG
(640 LB)
MIN.
Although the tires are specifically de-
signed for off-road use, a flat may still
occur. Therefore, it is recommended
to carry a tire pump and a repair kit.
Tire/Wheel Condition
Check tire for damage and wear. Re-
place if necessary.
Do not make a tire rotation. The front
and rear tires have a different size. The
tires are directional and their rotation
must be kept in a specific direction for
proper operation.
Wheel Removal
Loosen nuts then lift vehicle. Place a
support under vehicle. Remove nuts
then remove wheel.
At installation, it is recommended to
apply anti-seize lubricant on threads.
Gently tighten nuts in a criss-cross se-
quence then apply a final torque of
75 N•m (55 lbf•ft).
FRONT REAR
48 kPa 48 kPa
(7 PSI) (7 PSI)
35 kPa 35 kPa
(5 PSI) (5 PSI)
FRONT REAR
48 kPa 48 kPa
(7 PSI) (7 PSI)
35 kPa 35 kPa
(5 PSI) (5 PSI)
V01A08Y
1. Taper side of nut
CAUTION: Always use the recom-
mended wheel nuts (P/N 705 400 013).
Using a different nut could cause dam-
ages to the rim.

Steering System

Quest MAX and Traxter MAX Series
Throttle Cable Lubrication
The throttle cable must be lubricated
with Bombardier cable lubricant (P/N
293 600 041) or an equivalent.
WARNING
Using another lubricant could
cause the throttle lever/cable
sticking or stiffness.
1
137