Section Iv - Hands-On Riding - BOMBARDIER Quest Max 2004 Operator's Manual

SECTION IV – HANDS-ON RIDING
Objective
The purpose of this section is to:
a) Familiarize you with the pre-operation
check.
b) Remind you about the protective
clothing that should be worn by you
and your passenger while riding the
2-UP vehicle.
c) Have you drive the 2-UP vehicle and
perform all of the basic maneuvers.
Outline
A) Pre-Operation Checks
– Perform pre-operation check on the
2-UP vehicle, using the checklist
from the Operator's Guide and iden-
tify all controls.
B) Protective Clothing
– Wear the proper clothing when riding
the 2-UP vehicle:
1. approved helmet (with a rigid
chin guard for the passenger)
2. riding boots
3. gloves
4. eye protection
5. long sleeve shirt
6. long Pants
7. elbow pads (optional)
8. knee pads (optional)
9. kidney belt (optional).
70
C) Basic Maneuvers
– Drive the course performing all of
Expected Results
Upon completion of this section, you
should:
– Know how to do a pre-operation
– Know the proper clothing to be
– Have performed all of the basic riding
SAFETY TRAINING
the basic maneuvers described in
the attached DRIVING MANEUVER
LIST, without a passenger.
1. Dealer representative demonstrates
each of the maneuvers first.
2. You perform the maneuver with-
out passenger, after being shown
how.
3. Dealer representative checks off
the scoring chart when you have
completed the maneuvers satis-
factorily.
4. Dealer representative and you
continue with the maneuvers
one at a time until all have been
performed, and checked off.
check.
worn by you and the passenger
while riding your 2-UP vehicle.
maneuvers on the riding course.