BOMBARDIER Quest Max 2004 Operator's Manual page 97

The speedometer is located at the
middle of cluster and it is backlit when
the ignition switch is turned ON (either
position).
2
V01I1LY
1. Speedometer
2. Odometer/trip meter/hourmeter
3. Display selection button
Change from One Unit to the
Other
The speedometer is factory pre-set in
miles but it is possible to change is read-
ing to kilometer.
NOTE: The unit modification is applied
to the speedometer, odometer and trip
meter.
With the ignition switch OFF.
Press and hold the display selection
button then turn the ignition switch ON.
The number 514610 for a Quest MAX;
or 511--- for a Traxter MAX will ap-
pear in the display. Hold button until
the normal display comes back (ap-
proximately 7 seconds).
V04A16Y
QUEST MAX SERIES
3
1
V01A52Y
TRAXTER MAX SERIES
After these 7 seconds, the units
should be changed from miles to kilo-
meters or vice-versa.
NOTE: A dash appears on the left side
of the LCD display to indicate which
unit is used.
V04A17Y
This speedometer being used on many
models, it is factory pre-set. However,
if the speedometer shows a number
applying to another model, release and
repress the display button. The num-
ber should be change for the proper
number. Hold the button to change the
unit until the normal display comes
back.
Odometer/Trip Meter/Hourmeter
Combined LCD (Liquid Crystal Display)
display. Odometer records the total dis-
tance traveled in miles or in km/h
(00000). The trip meter records the dis-
tance traveled in miles or in km/h
(000.0) until it is reset. The last right digit
indicates the tenth of a mile or in km/h
(on trip meter mode only). It can be used
to approximately monitor the fuel tank
range or distance between two loca-
tions for instance.The hourmeter
records total hours when the ignition
switch is turned ON (H0000.0).
95