BOMBARDIER Quest Max 2004 Operator's Manual page 131

Unscrew the bleeding screw on the
top of thermostat housing.
Drain the system completely and rein-
stall the drain plug.
NOTE: On Traxter MAX series, lift
the rear of vehicle, about 75 mm (3 in).
Pinch hose between radiator and ther-
mostat housing with a large hose
pincher (P/N 529 032 500).
V04C0CY
QUEST MAX SERIES
V03C03Y
TRAXTER MAX SERIES
Fill the radiator until the coolant comes
out by the thermostat housing hole. In-
stall the bleeding screw then remove
the hose pincher.
Complete the radiator filling.
Check the level in the coolant reservoir
and refill if necessary.
Run engine at idle with the radiator cap
off. Slowly add additional coolant if
necessary.
At this point, wait until engine reaches
normal operating temperature. De-
press the throttle lever two or three
times; then add coolant if required.
Install radiator cap. Inspect all connec-
tions for leaks and check coolant level
in the reservoir.
Valve Adjustment
Quest MAX and Traxter MAX Series
Valve adjustment is not required on this
engine.
Spark Arrester
Quest MAX and Traxter MAX Series
The muffler must be periodically purged
of accumulated carbon.
WARNING
Never run engine in an enclosed
area. Never perform this opera-
tion immediately after the engine
has been run because exhaust
system is very hot. Make sure that
there are no combustible materi-
als in the area. Wear eye protec-
tion and gloves. Never stand be-
hind the vehicle while purging
exhaust system. Respect all ap-
plicable laws and regulations.
129