Motorola AP-6511 Reference Manual page 98

Motorola Solutions AP-6511 Access Point System Reference Guide
15.Refer to the
service frames are aggregated by the Access Point radio.
A-MPDU Modes
Minimum Gap
Between Frames
Received Frame Size
Limit
Transmit Frame Size
Limit
16.Use the
supported A-MSDU mode.
Available modes include Receive Only and Transmit and Receive. Using Transmit and Receive, frames up
to 4 KB can be sent and received. The buffer limit is not configurable.
17.Define a
whether interframe spacing is applied to Access Point transmissions or received packets, or both or none.
The default mode is Transmit and Receive.
Consider setting this value to None for high priority traffic to reduce packet delay.
5-46
Figure 5-26 Profile Overrides - Access Point Radio Advanced Settings tab
Aggregate MAC Protocol Data Unit (A-MPDU)
Use the drop-down menu to define the A-MPDU mode supported. Options
include Transmit Only, Receive Only, Transmit and Receive and None. The
default value is Transmit and Receive. Using the default value, long frames can
be both sent and received (up to 64 KB). When enabled, define either a
transmit or receive limit (or both).
Use the drop-down menu to define the minimum gap between A-MPDU frames
(in microseconds). The default value is 4 microseconds.
If a support mode is enable allowing A-MPDU frames to be received, define an
advertised maximum limit for received A-MPDU aggregated frames. Options
include 8191, 16383, 32767 or 65535 bytes. The default value is 65535 bytes.
Use the spinner control to set limit on transmitted A-MPDU aggregated
frames. The available range is between 0 - 65,535 bytes). The default value is
65535 bytes.
Aggregate MAC Service Data Unit (A-MSDU)
Reduced Interframe Spacing (RIFS)
field to define or override how MAC
drop-down menu to set or override the
mode using the drop-down menu. This value determines