Motorola AP-6511 Reference Manual page 321

2. Define the following Customize Event Filters
Severity
Module
Source
Device
Remove Filter
NOTE: Leave the Source, Device and Mobile Unit fields at the default setting of
00:00:00:00:00:00 to allow all MAC addresses.
3. Select the Add to Active Filters
table. When added, the filter uses the configuration defined in the Customize Event Filters field.
4. Refer to the Active Event Filters
a. To activate all the events in the Active Events Filters table, select the
stop event generation, select
b. To enable an event in the Active Event Filters table, click the event, then select the
Filter button.
NOTE: Filters cannot be persisted across sessions. They must be created every time a
new session is established.
5. Select View Events from the upper, left-hand, side of the Fault Management browser.
for the Fault Management configuration:
Set the severity of the event being filtered. Select from the following:
All Severities – All events are displayed irrespective of their severity
Critical – Only critical events are displayed
Error – Only errors are displayed
Warning – Only warnings are displayed
Informational – Only informational events are displayed
Select the module from which events are tracked. When a module is selected,
events from other modules are not tracked. Remember this when interested in
events generated by a particular module. Individual modules can be selected
(such as TEST, LOG, FSM etc.) or all modules can be tracked by selecting All
Modules.
Set the MAC address of the source device being tracked. Setting a MAC
address of 00:00:00:00:00:00 allows all devices to be tracked.
Set the device MAC address for the device from which the source MAC
address is tracked. Setting a MAC address of 00:00:00:00:00:00 allows all
devices.
To remove a filter, click the
table.
button to create a new filter and add it to the
table to set the following parameters:
Disable All Events.
Click to Remove link located in every row of the
Enable All Events
Diagnostics
Active Event Filters
button. To
Activate Defined
11-3