Motorola AP-6511 Reference Manual page 55

Figure 5-1 Device Basic Configuration screen
4. Set the following Configuration settings for the target device:
System Name
Building
Floor
5. Use the Profile drop-down menu to select an existing RF Domain for device membership.
If a profile configuration does not exist suiting the deployment requirements of the target device, select
the Create icon to create a new profile configuration, or select the
of a selected profile. For more information on profile configuration, see
Provide the selected device a system name up to 64 characters in length. This
is the device name that appears within the RF Domain or Profile the device
supports.
Assign the target a device a Building name representative of the location the
device is physically deployed. The name cannot exceed 64 characters.
Assigning a building name is helpful when grouping devices in Profiles, as
devices in the same physical deployment location may need to share specific
configuration parameters in respect to radio transmission and interference
requirements specific to that location
Assign the target a device a building Floor name representative of the location
the Access Point was physically deployed. The name cannot exceed 64
characters. Assigning a building Floor name is helpful when grouping devices
in Profiles, as devices on the same physical building floor may need to share
specific configuration parameters in respect to radio transmission and
interference requirements specific to that location.
Device Configuration
Edit icon to modify the configuration
Profile Configuration on page 7-1.
5-3