Motorola AP-6511 Reference Manual page 212

Motorola Solutions AP-6511 Access Point System Reference Guide
Use DHCP to obtain
Gateway/DNS
Servers
Secondary Addresses
9. Refer to the
10.Select the
DHCP packets on this interface.
Provide IP addresses for DHCP server relay resources.
The interface VLAN and gateway should have their IP addresses set. The interface VLAN and gateway
interface should not have DHCP client or DHCP Server enabled. DHCP packets cannot be relayed to a
DHCP Server. The interface VLAN and gateway interface cannot be the same.
11.Define the
Select either the Inside,
• Inside - The inside network is transmitting data over the network its intended destination. On the way
out, the source IP address is changed in the header and replaced by the (public) IP address.
• Outside - Packets passing through the NAT on the way back to the LAN are searched against to the
records kept by the NAT engine. There the destination IP address is changed back to the specific
internal private class IP address in order to reach the LAN over the network.
• None - No NAT activity takes place. This is the default setting.
12.Select
last saved configuration.
13.Select the
7-14
Select this option to allow DHCP to obtain a default gateway address, and DNS
resource for one virtual interface. This setting is disabled by default and only
available when the Use DHCP to Obtain IP option is selected.
Use the Secondary Addresses
to associate with VLAN IDs. The address provided in this field is used if the
primary IP address is unreachable.
DHCP Relay field to set the DHCP relay server configuration used with the Virtual Interface.
Respond to DHCP Relay Packets
Network Address Translation (NAT)
Outside
NOTE: Refer to Setting the Profile's NAT Configuration on page 7-39
creating a profile's NAT configuration.
OK button to save the changes to the Basic Configuration screen. Select
Security tab.
parameter to define additional IP addresses
option to allow the DHCP server to respond to relayed
direction.
or None radio buttons.
for instructions on
Reset to revert to the