Connect Sources And Turn The Cinema Projector On - Christie CP4230 Setup Manual

Section 2: Installation and Setup

2.17 Connect Sources and Turn the cinema projector On

After you install the lamp, you can connect external cinema servers and sources. Before you ignite the lamp for
the first time, use this procedure to ensure successful communication with input devices.
1. Assign the cinema projector a unique IP address and enter a baud rate:
• Tap Menu > Administrator Setup > Communications Configuration.
• Enter the IP address for the cinema projector in the IP Address field.
• Select a baud rate for the input device in the Serial Speed (Baud) list.
2. Enter lamp information:
• Tap Menu > Advanced Setup > Lamp History.
• Tap Add Lamp.
• Complete the fields in the Add Lamp dialog.
• Tap Save.
3. Tap and hold the green power button to turn the cinema projector on.
4. Complete a LampLOC™ alignment on the new lamp:
• Tap Menu > Advanced Setup > LampLOC™ Setup.
• Tap Do Auto.
5. Complete an optical alignment to optimize images displayed on screen.
6. Adjust optical components if required.
2-22 CP4230 Setup Guide
020-100669-03 Rev. 1 (05-2014)