Working With Replication Jobs; Run A Replication Job - Overland Storage SnapSAN S1000 User Manual

SnapSAN S1000 User Guide
a. If authentication is desired, select the CHAP option and enter the required
b. Use the options above the Node table to show different Target node lists and then
c. Click Next to continue.
5. Select a Target LUN, and click Next.
A new Replication job is created and listed on the Replication page.

Working with Replication Jobs

Use the Replications tab under Volume Configuration to work with replication jobs.
NOTE: Once a Replication job is created, do NOT reboot the Source array. If you reboot it, the virtual

Run a Replication Job

1. At the Replications tab on the Source array, click the menu button (▼) next to the
replication job number to open the operation menu.
2. Click Start to run the replication job.
10400310-003 01/2013
information.
select a node from the list.
disk name information will be lost and Replication job can no longer be started. This issue
could also be caused if the LUN is detached at the Target which causes the Replication job
to no longer be linked.
©2010-13 Overland Storage, Inc.
Working with Replication Jobs
8-7
