Overland Storage SnapSAN S1000 User Manual page 107
Servers
Hide thumbs
Also See for SnapSAN S1000:
- Quick start manual (9 pages) ,
- Replacement instructions (4 pages)
Table of Contents
Advertisement
SnapSAN S1000 User Guide
2. Select the source virtual disk which will be replicated to the Target subsystem, and
click Next.
NOTE: If a message appears saying that there is not enough space to create a replication job,
3. Enter the IP address of an iSCSI port on Controller 1 of the Target subsystem. Click
Next to continue.
4. Set the iSCSI authentication information.
SnapSAN Replication uses standard iSCSI protocols for data replication. The user has
to log on the iSCSI node to create the iSCSI connection for the data transmission.
Choose the authentication method and select the target node that will be used.
10400310-003 01/2013
refer
"Configure Snapshot Space"
©2010-13 Overland Storage, Inc.
below.
Configure Replication
8-6
Advertisement
Table of Contents
