Overland Storage SnapSAN S1000 User Manual page 11

SnapSAN S1000 User Guide
The individual components are all configured as removable modules and are accessible from
the rear.
This table describes the rear components:
Controllers
All controllers for the SnapSAN S1000 are shipped in separate packaging. Each comes with
its own Battery Backup Module (BBM).
NOTE: To facilitate support of your controllers, each BBM must be installed in the controller with
By default, the SnapSAN S1000 is configured as a single controller system. To change it to a
dual controller system with Master and Secondary controllers:
1. Install the optional Secondary controller.
2. Go to System Maintenance > Upgrade > Controller Mode.
3. Using the drop-down list, select Dual and click Apply.
For the dual controller setup, both controllers must be the same type (for example,
10Gb iSCSI controllers).
10400310-003 01/2013
1
3
Callout Description
1 Controller 2 (Optional)
2 Controller 1
3 Power Supply Unit 1
4 Fan Module
5 Power Switch ("|"=ON and "O"=OFF)
6 Power Supply Unit 2
7 Fan Module
which it came packaged. All controllers and batteries must be registered with the SnapSAN
S1000 in which they are installed.
©2010-13 Overland Storage, Inc.
4 5 6
Hardware
2
7
Rear Label
CL2
CL1
PSU1
FAN1/2
(none)
PSU2
FAN3/4
1-4
