Overland Storage SnapSAN S1000 User Manual page 115

SnapSAN S1000 User Guide
3. After the data is synchronized, change the cloning job to a replication job by selecting
Change to Replication from the drop-down menu of Source virtual disk.
The values at the Clone column changes from the target virtual disk name to Rep.
4. Deactivate the RAID group which the Target virtual disk resides in and move all
physical disks of the RAID group to the Target subsystem.
5. Activate the RAID group in the Target subsystem and attach the Target virtual disk
to a LUN ID.
6. Switch to Replications tab of the Source subsystem and click Rebuild to rebuild the
replication job which was changed from a cloning job.
7. Select the replication job to rebuild.
8. Follow the steps for creating a new replication job.
Refer to
If a wrong target virtual disk is selected when rebuilding the replication job, a
mismatched error message is displayed and the rebuilding stops.
10400310-003 01/2013
Changing a cloning job to a replication job is only available when the cloning
CAUTION:
job is complete. This change is irreversible.
"Configure Replication."
©2010-13 Overland Storage, Inc.
First Time Best Practices
8-14
