Chapter 8
Introduction
Replication is a new function on the SnapSAN S1000 redundant RAID subsystem. It helps
users to replicate data easily through LAN or WAN from one S1000 to another. Users can
learn from this document about how to configure Replication on the S1000 storage array,
and how redundancy works on Replication when a controller fails on a source or target RAID
subsystem.
Network configuration
The following are the default address used but your own internal address can be used.
IP settings on source subsystem:
Controller 1, iSCSI port 1: 192.168.1.1/24
Controller 2, iSCSI port 1: 192.168.1.5/24
IP settings on target subsystem:
Controller 1, iSCSI port 1: 192.168.1.11/24
Controller 2, iSCSI port 1: 192.168.1.15/24
10400310-003 01/2013
iSCSI port 2: 192.168.1.2/24
iSCSI port 3: 192.168.1.3/24
iSCSI port 4: 192.168.1.4/24 (Replication port)
iSCSI port 2: 192.168.1.6/24
iSCSI port 3: 192.168.1.7/24
iSCSI port 4: 192.168.1.8/24 (Replication port)
iSCSI port 2: 192.168.1.12/24
iSCSI port 3: 192.168.1.13/24
iSCSI port 4: 192.168.1.14/24
iSCSI port 2: 192.168.1.16/24
iSCSI port 3: 192.168.1.17/24
iSCSI port 4: 192.168.1.18/24
©2010-13 Overland Storage, Inc.
Replication
8-1