Powering On / Off; Power Up The Snapsan S1000; Powering Down The Snapsan S1000 - Overland Storage SnapSAN S1000 User Manual

SnapSAN S1000 User Guide
4. Install the Rail Kit onto the unit and insert it into the rack.
5. Install the Disk Drive assemblies.
6. Connect the data and management cables based on the network plan.
7. Attach the power cords and power ON the unit.
8. Confirm or set the IP address and start the configuration for your needs.

Powering ON / OFF

Power Up the SnapSAN S1000

The power switch is located in the center of the rear panel's lower section. To turn the
storage array ON, press "|" (switch top).
After you turn the power ON, the System performs a self-test process, which takes a couple
of minutes.

Powering Down the SnapSAN S1000

If it becomes necessary to power down the system, it is recommended using a normal,
controlled shutdown from either the Front Panel Display or the Web Management Interface
to ensure all data is flushed from the cache first.
Shutdown Using the Web Management Interface
Using the Web Management Interface:
1. Select System Maintenance > Reboot and Shutdown.
2. Click the Shutdown icon.
3. When the "System Shutdown" message is shown on the Front Panel Display, move the
main power switch to OFF (O).
Shutdown Using Front Panel Display
At the Front Panel Display:
1. Power off the unit using a normal shutdown.
a. Press ENT.
b. Press ▼ twice to show Reboot/Shutdown, and press ENT.
c. Press ▼ once to show Shutdown, and press ENT.
d. Press ▲ once to highlight Yes, and press ENT.
A controlled shutdown begins.
10400310-003 01/2013
©2010-13 Overland Storage, Inc.
Powering ON / OFF
2-4
