SnapSAN S1000 User Guide
3. At the System Maintenance > Upgrade tab, locate the Replication License area.
4. Click the Browse button, navigate to where you downloaded the license, a select it.
5. Click Apply.
After the license key is activated, a message is displayed requesting a reboot of the
S1000 to have the license take effect.
6. Click Reboot.
After the reboot, the Replication license status is displayed as "Activated" on the
System Information page.
Set Up the Replication Port On The Source
Replication uses the last iSCSI port (number 4) on the Source controllers to replicate the
data. When Port 4 is configured as the replication port, it is no longer available as a host
iSCSI port until it is reconfigured as the normal iSCSI port again.
1. Go to iSCSI configuration > Network Setup.
10400310-003 01/2013
©2010-13 Overland Storage, Inc.
Configure Replication
8-3