Aprs Message Replying; Automatic Message Replying - Yaesu FTM-350 Series Manual

T
RANSMIT AN
A M
UTOMATIC ESSAGE
You may transmit a reply message which was programmed beforehand automatically when
the transceiver receives a message (Factory default: The transceiver transmits reply to all
received messages).
1. Press the [ SET ] key to enter the Set Mode.
2. Rotate the left side [ DIAL ] knob to select "APRS/PKT" group, then press the left side
[ DIAL ] knob.
3. Rotate the left side [ DIAL ] knob to select
Set Mode item "E28 MESSAGE RE-
PLY", then press the left side [ DIAL ] knob
to enable modification of this Set Mode
item.
4. Rotate the left side [ DIAL ] knob to select "1: REPLY" item, then press the left side
[ DIAL ] knob.
5. Rotate the left side [ DIAL ] knob to select "ON", then press the left side [ DIAL ] knob to
save the new setting.
6. Rotate the left side [ DIAL ] knob to select "2: CALLSIGN" item, then press the left
side [ DIAL ] knob.
7. Program the Callsign and SSID of the station you wish to reply to using the same
procedure as described previously.
8. Rotate the left side [ DIAL ] knob to select "3: TEXT" item, then press the left side
[ DIAL ] knob.
9. Program the message for the station you wish to reply to using the same procedure as
described previously.
10. When you have completed your setting, press the [ ENT ] key to save the new setting,
then press the [ ESC ] key three times to exit from Set Mode.
FTM-350 S
ERIES
APRS M
ESSAGE
R
EPLYING
APRS ® M
ANUAL
APRS ®
R
EPLYING
M
ESSAGE
59