Yaesu FTM-350 Series Manual page 44

T
RANSMIT AN
D R
IGIPEATER OUTE
When selecting a Path Route (PATH 1 - PATH 4, FULL 1, or FULL 2) on Set Mode item
"E20 DIGI PATH SELECT", you must input the Callsign or Alias of that digipeater via
Set Mode items "E21 DIGI PATH 1" - "E24 DIGI PATH 4", "E25 DIGI PATH FULL
1", and "E26 DIGI PATH FULL 2". Set Mode items "E21 DIGI PATH 1" - "E24 DIGI
PATH 4" enable you to input up to two Callsign or Alias. Set Mode items "E25 DIGI
PATH FULL 1" and "E26 DIGI PATH FULL 2" enable you to input up to eight Callsign
or Alias.
For example, input the Callsign into the Set Mode item "E21 DIGI PATH 1".
1. Press the [ SET ] key to enter the Set Mode.
2. Rotate the left side [ DIAL ] knob to select "APRS/PKT" group, then press the left side
[ DIAL ] knob.
3. Rotate the left side [ DIAL ] knob to select
Set Mode item "E21 DIGI PATH 1", then
press the left side [ DIAL ] knob to enable
selection of this Set Mode item.
4. Rotate the left side [ DIAL ] knob to select "1 ADDR1:" item, then press the left side
[ DIAL ] knob.
5. Input the callsign and SSID of the digipeater which you wish to path through by using
the left side [ DIAL ] knob (select the number/character) and [
the cursor).
6. Press the left side [ DIAL ] knob to save the new setting, then press the [ ESC ] key three
times to exit from Set Mode.
44
APRS
O
PTIONAL
A S
DDRESS ETTING
® B
EACON
S
ETTINGS
)
FTM-350 S
ERIES
] / [ ] key (to move
APRS ® M
ANUAL