Yaesu FTM-350 Series Manual page 77

E34: SmartBeaconing
Function:
Available Values:
Default:
STATUS:
LOW SPEED:
HIGH SPEED:
SLOW RATE:
FTM-350 S
ERIES
APRS/PKT S
Selects the various parameters of SmartBeaconing
The SmartBeaconing
missions based on the received GPS data (Movement speed, and move-
ment direction etc.).
1 STATUS: OFF, TYPE1, TYPE2, or TYPE3
2 LOW SPEED: 2 ~ 30
3 HIGH SPEED: 3 ~ 70
4 SLOW RATE: 1 min ~ 100 min
5 FAST RATE: 10 sec ~ 180 sec
6 TURN ANGLE: 5° ~ 90°
7 TURN SLOPE: 1 ~ 255
8 TURN TIME: 5 sec ~ 180 sec
1 STATUS: OFF
2 LOW SPEED: 5
3 HIGH SPEED: 70
4 SLOW RATE: 30 min
5 FAST RATE: 120 sec
6 TURN ANGLE: 28°
7 TURN SLOPE: 26
8 TURN TIME: 30 sec
These registers sum up (combine) the "LOW SPEED" through "TURN
TIME" items parameters in the "TYPE 1", "TYPE 2", or "TYPE 3"
settings.
When STATUS is set to "TYPE 1", "TYPE 2", or "TYPE 3", the
SmartBeaconing
When STATUS is set to "OFF", the SmartBeaconing
disabled.
This item designates the lower speed threshold. The transceiver trans-
mits an APRS beacon when your vehicle speed becomes lower than
the selected speed. The transmission interval time of the APRS bea-
con is set in "SLOW RATE" item. (The speed unit is determined from
the Set Mode item "E12 APRS UNITS".)
This item designates the higher speed threshold. The transceiver trans-
mits an APRS beacon when your vehicle speed becomes higher than
the selected speed. The transmission interval time of the APRS bea-
con is set in "FAST RATE" item. (The speed unit is determined from
the Set Mode item "E12 APRS UNITS".)
This item designates the transmission interval time of the APRS bea-
con at low vehicle speeds.
APRS ® M
ANUAL
function regulates the APRS beacon trans-
is activated with parameters of that setting.
M
ET ODE
.
function is
77