Yaesu FTM-350 Series Manual page 73

INPUT:
WP FORMAT:
WP FILTER:
Important Note: If you connect your personal computer to the transceiver, verify the cor-
rect settings for "E16 COM PORT SETTING" and "E17: DATA BAND SELECT".
E17: DATA BAND SELECT
Function:
Available Values:
Default:
Note: An "A" icon appears in the S- meter area of the APRS operation band. A "D" icon
appears in the S- meter area of the DATA operation band.
E18: DATA SPEED
Function:
Available Values:
Default:
FTM-350 S
ERIES
APRS/PKT S
When this item is set to "GPS OUT", the transceiver outputs the GPS
data (NMEA data: GGA & RMC) from the COM port.
When this item is set to "PACKET", the transceiver outputs the Packet
data from the COM port.
When this item is set to "WAYPOINT", the transceiver outputs the
Waypoint data to the COM port.
This item selects the input data type of the COM port.
When connecting an external GPS receiver (not supplied: enabling
the outputs $GPRMC, $GPGAA, and $GPGSV data) to the trans-
ceiver through the COM port, set this item to "GPS".
This item determines the output of the selected number of digits from
the callsign of the APRS Beacon station included in the Waypoint
data when the OUTPUT item is set to "WAYPOINT".
For example, "W6DXA-14" is
"NMEA6": DXA-14
"NMEA7": 6DXA-14
"NMEA8": W6DXA-14
"NMEA9": W6DXA-14
This item determines the output APRS beacon to the COM port when
the OUTPUT item is set to "WAYPOINT".
Selects the operating band for the DATA mode.
1 APRS: MAIN BAND, SUB BAND, L-BAND FIX,
R-BAND FIX, L=TX / R=RX, or L=RX / R=TX
2 DATA: MAIN BAND, SUB BAND, L-BAND FIX, R-BAND
FIX, L=TX / R=RX, or L=RX / R=TX
1 APRS: L-BAND FIX
2 DATA: R-BAND FIX
Selects the baud rate for the DATA mode.
1 APRS: 1200 bps or 9600 bps
2 DATA: 1200 bps or 9600 bps
1 APRS: 1200 bps
2 DATA: 1200 bps
APRS ® M
ANUAL
M
ET ODE
73