Yaesu FTM-350 Series Manual page 41

T
8. Rotate the left side [ DIAL ] knob to select
"1: SELECT" item, then press the left side
[ DIAL ] knob.
9. Rotate the left side [ DIAL ] knob to select
the Status Text register ("TEXT 1" through "TEXT 5") you wish to send, then press
the left side [ DIAL ] knob.
10. Rotate the left side [ DIAL ] knob to select
the "2: TX RATE" item, then press the left
side [ DIAL ] knob.
11. Rotate the left side [ DIAL ] knob to select
the rate you want to transmit your Status Text ("1/1" ~ "1/8" and "1/2 ( FREQ ) " ~
"1/8 ( FREQ ) ").
"1/1" ~ "1/8":
"1/2 ( FREQ ) " ~ "1/8 ( FREQ ) ": Transmits the Status Text at the designated rate ("1/2"
13. Press the left side [ DIAL ] knob to save the new setting, then press the [ ESC ] key
several times to exit from Set Mode.
When the APRS beacon transmits, the Status Text is transmitted with the APRS beacon.
a b c d e f g h i j k l m n o p q r s t u v w x y z
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
0 1 2 3 4 5 6 7 8 9
( Space ) ! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ~
A colon (:) is displayed on the 21, 29, and 43 spaces in the comment box. If the
comment is longer than a colon position,
some transceivers cannot display the
entire comment. We recommended that
the status comments be as short as pos-
sible.
FTM-350 S
ERIES
RANSMIT AN
O
PTIONAL
Transmits the Status Text at the designated rate ("1/1"
(every time) ~ "1/8" (once in eight times)) when the
APRS Beacon is transmitted.
(once in two times) ~ "1/8" (once in eight times)) when
the APRS Beacon is transmitted. However, the fre-
quency data of the band opposite the APRS band
(QSY), the sub audio information (squelch type and its
tone frequency/code), and the repeater shift frequency
data are included each time the APRS Beacon is trans-
mitted according this selection.
A
VAILABLE
APRS ® M
ANUAL
APRS
S
ETTINGS
C
HARACTERS
® B
EACON
41