Yaesu FTM-350 Series Manual page 71

Default:
AUTO:
INTERVAL:
PROPORTIONAL: This item enables changing the transmit APRS beacon path route au-
DECAY:
FTM-350 S
ERIES
APRS/PKT S
1 AUTO:
2 INTERVAL:
3 PROPORTIONAL: ON
4 DECAY:
5 LOW SPEED:
6 RATE LIMIT:
This item selects the automatic transmission method of the APRS bea-
con.
When this item is set to "OFF" (no icon), your APRS beacon does not
transmit automatically. The transceiver only transmits your APRS
beacon when the [ B-TX ] key is pressed.
When this item is set to "ON", the " " icon appears on the display,
and the APRS beacon transmits in accordance with the interval deter-
mined by "2 INTERVAL" of the Set Mode item "E15 BEACON TX".
When this item is set to "SMART" (" " icon appears on the display),
the APRS beacon transmits in accordance with the interval determined
by Set Mode item "E34 SmartBeaconing".
This item sets the interval time to transmit the APRS beacon auto-
matically when "1 AUTO" of the Set Mode item "E15 BEACON
TX" is set to "ON".
tomatically according to the "INTERVAL" time determined from the
item of this Set Mode.
For example, if you set this item to "ON" when Set Mode item "E20
DIGI PATH SELECT" is set to "WIDE1-1, WIDE2-1", and the "IN-
TERVAL" item is set to "5min", the APRS beacon path changes as
follows:
a. 5 minute WIDE1-1, WIDE2-1
b. 10 minute (none)
c. 15 minute WIDE1-1
d. 20 minute (none)
e. 25 minute WIDE1-1, WIDE2-1
repeats steps b - e afterward
When the Set Mode item "E20 DIGI PATH SELECT" is set to "OFF",
"FULL1", or "FULL2", this item is ignored.
This function extends the interval of the APRS beacon when the ve-
hicle is stopped.
When this item is set to "ON", extends the setting value of the "IN-
TERVAL" item step by step when the vehicle is stopped.
For example, if the "INTERVAL" item is set to "1min", then when the
APRS ® M
ANUAL
OFF
5min
ON
3
30 sec
M
ET ODE
71