Aprs Navigation - Yaesu FTM-350 Series Manual

R
ECEIVING AN
You may navigate to a specific APRS station when the optional FGPS-1 or FGPS-2 GPS
Antenna Unit is installed.
1. If necessary, press the [ F ] key repeatedly,
until the [ SMART FUNCTION ] key's cat-
egory changes to "F-3" mode, then press
the [ S LIST ] key to open the "Station List"
window.
2. Rotate the left side [ DIAL ] knob to select
the APRS station which you wish to navi-
gate to.
3. Press the [ F ] key repeatedly, until the
[ SMART FUNCTION ] key's category
changes to "S-3" mode, then press the
[ NAVI ] key to open the "NAVI" page and
initiate navigation. Drive your vehicle so
that the "CAR" icon is pointing toward the
"D" symbol in the Compass display.
Advice 1: The "D" symbol is the direction
of the APRS station (destination).
Advice 2: Press the [ POS ] key to display the receiving data of the APRS station (des-
tination).
Advice 3: When the APRS station (destination) moves, the APRS station's position
data is updated automatically.
Advice 4: The position data of the APRS
station is memorized into GRP4 of the
Point Memory. In the position data of the
APRS station, a blinking " " icon will ap-
pear at the right side of the station name
on the "NAVI" page and the "Point List" window.
5. When your vehicle nears the APRS station (destination), an alarm beep is emitted and
the "GOAL!" notation appears in the Compass display.
6. Press the [ CANCEL ] key to cancel navi-
gation.
Advice: Refer to page 43 of the FTM-350
Series Operating Manual regarding the
Navigation setup.
32
APRS
APRS N
AVIGATION
Indicates that the destination is the APRS station
Direction of the destination
® B
EACON
Distance to the destination
FTM-350 S
ERIES
APRS ® M
ANUAL