Yaesu FTM-350 Series Manual page 74

APRS/PKT S
E19: DATA SQUELCH
Function:
Available Values:
Default:
RX BAND:
TX/RX BAND:
TX:
E20: DIGI PATH SELECT
Function:
Available Values:
Default:
E21: DIGI PATH 1
Function:
Program the address information (callsign or alias etc) of the digipeater that you selected as
"PATH 1" in Set Mode item "E20 DIGI PATH SELECT" (2 path).
E22: DIGI PATH 2
Function:
Program the address information (callsign or alias etc) of the digipeater that you selected as
"PATH 2" in Set Mode item "E20 DIGI PATH SELECT" (2 path).
E23: DIGI PATH 3
Function:
Program the address information (callsign or alias etc) of the digipeater that you selected as
"PATH 3" in Set Mode item "E20 DIGI PATH SELECT" (2 path).
E24: DIGI PATH 4
Function:
Program the address information (callsign or alias etc) of the digipeater that you selected as
"PATH 4" in Set Mode item "E20 DIGI PATH SELECT" (2 path).
74
ET
Configures the Squelch settings for APRS, DATA, and TX.
1 APRS: RX BAND or TX/RX BAND
2 DATA: RX BAND or TX/RX BAND
3 TX: OFF or ON
1 APRS: RX BAND
2 DATA: RX BAND
3 TX: ON
Does not transmit the APRS/DATA data when the RX band's squelch
circuit is open.
Does not transmit the APRS/DATA data when the TX and RX band's
squelch circuits are both open.
Determine the SQL port (pin 6 of the DATA jack). When this item is
set to "ON", the external TNC can not initiate transmit while the trans-
ceiver is transmitting.
Selects the APRS packet path you wish to path through.
OFF / WIDE1-1(fixed value) / WIDE1-1,WIDE2-1(fixed value) /
PATH 1 / PATH 2 / PATH 3 / PATH 4 / FULL 1 or FULL2
WIDE1-1,WIDE2-1 (fixed value)
Sets the APRS packet path.
Sets the APRS packet path.
Sets the APRS packet path.
Sets the APRS packet path.
M
ODE
FTM-350 S APRS ® M
ERIES ANUAL