Epson Stylus Photo R1900 Service Manual page 79

EPSON Stylus Photo R1900/R2880/R2000
3. Disengage the nine hooks on the bottom of the Panel Unit, and remove the Panel
Unit while pulling out its tab.
4. Remove the Panel FFC from the Panel Unit.
5. Disconnect the Panel FFC and CDR Sensor cable from the Panel Board connectors
and remove the Panel Unit.
Hook
Tab
Figure 4-14. Removing the Panel Unit (2)
Disassembly And Assembly
Refer to Figure 4-15.
Panel Unit
Connector
CDR Sensor
cable
Panel FFC
Removing the Housings
 Be careful not to get the Panel FFC caught underneath the
hooks on the Panel Unit.
 Secure the Panel FFC with double-sided Tape on the Panel
Unit.
 Route the CDR Sensor cable as shown in the following figure.
Figure 4-15. Reinstalling the Panel Unit
Revision E
Panel FFC
Double-sided Tape
CDR Sensor cable
79
Confidential