Ohp Transparencies - Ricoh Printer Quick Installation Manual

5. Paper and Other Media
Both-sided printing
Additional cautions

OHP transparencies

Printer setup
Printer driver setup
Enabled paper feeding tray
5
Number of sheets that can be set
Both-sided printing
Additional cautions
Envelopes
Printer setup
90
Not possible
Print speed is slightly slower than when using plain paper.
Make the following settings using the control panel:
• Press the [Menu] key, select [Paper Input], and then select
[Transparency] for the bypass tray's paper type.
Click [OHP Transparency] in the "Paper type:" list.
This paper type can be printed only from the bypass tray.
Bypass Tray: 1 sheet
Not possible
• Print speed for OHP transparencies is slower than for plain
paper.
• Depending on the setting made for mode switching, the
printer goes into standby mode 30 or 40 seconds after
receiving a job.
• We recommend you use a 4000 ANSI lumen or brighter
overhead projector to project OHP transparencies.
• When printing on OHP transparencies that have a print side,
load them with the print side facing up on the bypass tray.
• When printing multiple pages, remove output sheet as it
comes out. Do not leave multiple sheets remaining on the
output tray.
Make the following settings using the control panel:
• Press the [Menu] key, select [Paper Input], and then select
[Thick Paper] for the selected tray's paper type.
• Paper type settings made using the printer driver have
priority over paper type settings made using the control
panel settings.