Ricoh Printer Quick Installation Manual page 183

Remove Misfeed Internal Path/Open Front Cover
Paper is jammed in the internal paper feed path.
• Open the front cover and remove jammed paper.
• See p.186 "When "Remove Misfeed Internal Path" Appears"
Remove Misfeed Paper Tray/Pull out Tray
Paper is jammed in the specified input paper tray.
• Remove paper from the input paper tray and then reload paper. Then open the front cover and then
close it again, so the error message disappears.
• See p.184 "When "Remove Misfeed Paper Tray" Appears"
Remove Misfeed Paper Exit Cover/Open Paper Exit Cover
Paper is jammed under the paper exit cover.
• Open the front and rear cover and remove jammed paper.
• See p.189 "When "Remove Misfeed Paper Exit Cover" Appears"
Remove Paper Standard Tray
The standard output tray is full.
• Remove the paper from the standard output tray.
Replace Print Cartridge
It is time to replace the waste toner.
The printer is out of toner.
• Replace the toner cartridge.
• See p.123 "Replacing the Toner Cartridge (Print Cartridge)".
Replace Print Cartridge soon
The printer is almost out of toner.
• Prepare a new toner Cartridge.
Reset Fusing Unit correctly
The fusing unit is not set correctly or is not set, or your fusing unit is improper.
• Set the fusing unit correctly, or set the proper fusing unit.
• See p.128 "Replacing the Maintenance Kit".
Reset the Job or Form Feed/Paper Size: Paper Type:
The printer detected that the actual paper type and size are not the same as the paper tray size setting and
the paper type setting.
Error & Status Messages on the Control Panel
9
165