Ricoh Printer Quick Installation Manual page 272

1. Preparing for Printing
6. Click [Local printer] or [Local Printer attached to this computer], and then click [Next >].
If you are using other than Windows Vista, click [Next >]
7. Click [Create a new port:].
1
8. Click [LPR Port], and then click [Next >].
If you are using other than Windows 2000, [Standard TCP/IP Port] in [Create a new port].
9. Enter the printer's IP address in the [Name or address of server providing lpd] box.
10. Enter "Ip" in the [Name of printer or print queue on that server box], and then click [OK].
11. Check that the name of the machine whose driver you want to install is selected, and then
click [Next >].
12. Change the printer name if you want, and then click [Next >].
Select the [Yes] check box to configure the printer as default.
Step 13 does not apply for Windows Vista users.
13. Specify whether or not to share the printer, and then click [Next >].
14. Specify whether or not to print a test page.
If you are using other than Windows Vista, click [Next >].
15. Click [Finish].
The printer driver installation starts.
• A user code can be set after the printer driver installation. For information about user code, see the
printer driver Help.
• To stop installation of the selected software, click [Cancel] before the installation is complete.
• Auto Run may not work with certain operating system settings. In that case, launch "Setup.exe" on the
CD-ROM root directory.
• A message appears if there is a newer version of the printer driver already installed. If there is, you
cannot install the printer driver using Auto Run. If you still want to install the printer driver, use [Add
Printer]. See "Messages Displayed When Installing the Printer Driver".
• p.49 "Messages Displayed When Installing the Printer Driver"
Using the WSD port
This section explains installation when using the WSD port.
• The WSD port can be used only under Windows Vista and Windows Server 2008.
34