Address Programming; Communication And Report Programming; Receiver Programming - Bosch AMAX 2100 Installation Manual

AMAX 2100 / 3000 / 4000
9

Address Programming

The control panel programming options are stored in a non-volatile flash memory. This
memory has all relevant configuration and user-specific data even after a total power loss.
Because the data retention time is quite long without power, reprogramming is not required
after powering up the control panel.
Programming with keypad is possible only when all of zones in the system are in disarmed
status and no alarm is activated. The installer code is required for programming.
Notice!
It is not recommended to use other keypads or methods simultaneously to program the
system while programming with the current keypad.
The following chapters show an overview of all relevant programming options and their
addresses according to the descriptions in the chapter Settings, page 32.
9.1

Communication and Report Programming

9.1.1

Receiver Programming

Receiver No.
1
Bosch Sicherheitsysteme GmbH
Option
Transmission format for receiver (0 = not
used, 1 = CID, 2= SIA, 3 = Conettix IP, 4 = SIA
DC 09, 5 = SIA DC09 (2x ID))
Telephone number / IP address and port
Subscriber ID number (0 – 9, B – F)
Anti-replay for receiver (0 = disabled, 1 =
enabled)
Acknowledge wait time for receiver (05 - 99
seconds )
Network polling time for receiver (001 - 999
minutes )
DC09 data format (1 = ADM-CID, 2 = SIA-
DCS)
DC09 acct1 length (3 – 16, all other input is
treated as "3")
DC09 acct1 (0 - 9 = 0 - 9, 10=A, 11=B, 12=C,
13=D, 14=E, 15=F)
DC09 acct2 length length (3 – 16, all other
input is treated as "3")
Installation Guide
Address Programming | en
Address Default
0023 1
0000 – 0016 15
0017 – 0022 000000
0024 1
EN=1
0025 – 0026 05
0027 – 0029 001
0140 1
0141 – 0142 06
0143 – 0158 000001
000000
0000
0159 – 0160 06
2014.11 | 02 | F.01U.267.112
105