Bosch AMAX 2100 Installation Manual page 76

76 en | Settings AMAX 2100 / 3000 / 4000
18 - AWAY Armed
This output is operated when the system is in AWAY mode.
The output is reset when the programmed output time ends.
If the output time is set to 000, the output will continue until the system is disarmed.
19 - STAY Armed
This output is operated when system is in STAY mode.
The output is reset when the programmed output time ends.
If the output time is set to 000, the output will continue until the system is disarmed.
20 - Reset
This output is operated when a reset is performed in the system.
21 - Follow Zone Event Zone Number
This output imitates the zone alarm state. The output is operated when an alarm or a tamper
is generated in the corresponding zone.
The output is reset when the system arming or disarming or the output time ends.
22 - RF Keyfob Button 3
If the output time of this output is set to 000, the keyfob button 3 works as a toggle:
This output is operated when the keyfob button 3 is pressed.
The output is reset when the keyfob button 3 is pressed again.
23 - RF Keyfob Button 4
If the output time of this output is set to 000, the keyfob button 4 works as a toggle:
This output is operated when keyfob button 4 is pressed.
The output is reset when the keyfob button 4 is pressed again.
24 - Chime Indication
This output is operated when a chime indication occurs.
25 - Verified Alarm
This output is operated when a verified alarm occurs.
26 - Unverified Alarm
This output is operated when an unverified alarm occurs.
27 - Technical Alarm
This output is operated when a technical alarm occurs.
28 - Bypassed Zone
This output is operated when a zone is bypassed.
29 - Ready to Arm
This output is operated when the system is in ready to arm state.
30 – Walk Test Output Mode
This output is operated when the system is in walk test mode.
2014.11 | 02 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH