Bosch AMAX 2100 Installation Manual page 80

80 en | Settings
4.
P
Caution!
If you do not enter the programming mode first, which connects the blank ICP-EZPK
!
Programming Key (blue) to the AMAX panel, no data can be uploaded / downloaded.
An unknown error may be caused if the programming mode is not exited before removing the
programming key.
Programming Key
With the programming key, the programming parameters of the current AMAX panel can be
transferred to other systems with the same applications.
Copying Parameters of the Alarm AMAX Panel to the Key
How to copy the programming data of the memory of the AMAX panel onto the programming
key with the keypad:
1.
2.
3.
LED/LCD keypads can also be used to copy the AMAX panel parameters to key parameters.
Copying Key Parameters to the AMAX Panel
How to copy the programming data of the programming key onto the alarm center.
1.
2.
3.
LED/LCD keypads can also be used to copy key parameters to the AMAX panel.
2014.11 | 02 | F.01U.267.112
Enter [960] + [#] to exit the programming mode.
The system resets and returns to the disarmed state. The programming key becomes your
standard data pattern for future AMAX panel programming.
Connect the programming key to the plug on top of the Printed Circuit Board (PCB) of
the AMAX panel. Please note that the direction of the programming key should be
consistent with the direction marked on the PCB.
Select text keypad installation menu ADDRESS / KEY PROGR – COPY DATA TO KEY and
press [#].
After successfully copying the programming data of the AMAX panel to the programming
key, a confirmation tone occurs. Wrong prompt tone and display of Failure of AMAX
Panel Parameters to Key indicate a damage of the programming key data. In this case,
the data needs to be copied onto the programming key again.
Unplug the programming key from the AMAX panel.
Connect the programming key to the Printed Circuit Board (PCB) plug of the AMAX panel.
Please note that the direction of the programming key should be consistent with the
direction marked on the PCB.
Select text keypad installation menu ADDRESS / KEY PROGRAM – COPY DATA TO
PANEL and press [#].
After successfully copying the programming data in the programming key to the AMAX
panel, a confirmation tone occurs. Wrong prompt tone and display of Failure of Key
Parameters to AMAX Panel indicate a damage of the programming key data. In this case,
the data needs to be copied onto the AMAX panel again.
Unplug the programming key from the AMAX panel.
Installation Guide
AMAX 2100 / 3000 / 4000
Bosch Sicherheitsysteme GmbH