Installation; Module Installation - Bosch AMAX 2100 Installation Manual

AMAX 2100 / 3000 / 4000
6

Installation

This chapter describes the installation and the system power up of the AMAX panel.
Danger!
Electricity
Injuries due to electricity are possible if the system is not operated correctly or if the system
is opened or modified not accordingly to this manual.
–
–
–
–
–
–
Caution!
Installation
!
Damage or malfunction of the system is possible if the system is not mounted and installed
correctly.
–
–
–
For the main steps on how to get the system into operation easily and quickly, please also
refer to the Quick Start Guide.
6.1

Module Installation

The enclosure contains only PCBs and transformers of the fixed AMAX panel for installation,
no other hardware.
1.
2.
3.
4.
5.
6.
Notice!
Make sure to choose a appropriate positioning screw kit when you install the system in a non-
load bearing wall.
Expansion modules can be placed in the enclosure of the AMAX panel. Several places are
available. Figure 6.1. and figure 6.2 show the standard enclosure installation and the
enclosure installation with a mounting plate.
Bosch Sicherheitsysteme GmbH
Disconnect all Telecommunication Network Connectors before switching off the power.
To switch off the power, make sure to have a circuit breaker available.
Make sure that the system is switched off during the installation and wiring process.
Only open or modify the system accordingly to this manual.
Make sure to connect the system to a socket-outlet with a protective grounding contact.
Only qualified installers /service personnel are allowed to install this system.
Place the system inside the monitored area on a stable surface.
Make sure to mount keypads on the inner side of the monitored area.
Once the system is tested and ready to use, secure the enclosure door and additional
enclosures with screws.
Open the knockout holes for wiring in the module.
Position two upper mounting holes on the installation wall with the module.
Pre-install screws on the mounting holes (provided by the installer).
Mount the screws on the module.
Fasten the screws.
Fix the two lower mounting holes with screws.
Installation Guide
Installation | en 25
2014.11 | 02 | F.01U.267.112