Bosch AMAX 2100 Installation Manual page 145

AMAX 2100 / 3000 / 4000
4
Supervise:
1.
2.
P
–
1-8 RF Repeater 1-8 Missing
Condition:
No status report is send to the receiver in the RF supervision interval if a wireless module is
enabled.
Restore:
4
Supervise:
1.
2.
P
–
Configuration Conflict Sensors
Condition:
A wireless zone configuration is in error condition.
Restore:
4
Supervise:
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
4
P
Configuration Conflict Repeaters
Condition:
A repeater configuration is in error condition.
Restore:
4
Supervise:
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
4
P
Configuration Conflict Keyfobs
Condition:
A keyfob configuration is in error condition.
Restore:
4
Bosch Sicherheitsysteme GmbH
Restore all wireless zones to a normal condition and reset the fault. For more
information, refer to RF Devices, page 78.
Report the wireless zone fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off when there is no other system fault.
RF Repeater Failure
Make sure that status reports are sent to the receiver in the RF supervision interval and
reset the fault. For more information, refer to RF Devices, page 78.
Report the repeater missing fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off when there is no other system fault.
RF Config Failure
Restore all wireless zones to a normal condition and reset the fault. For more
information, refer to RF Devices, page 78.
Reset the fault.
The FAULT indicator is turned off when there is no other system fault.
Restore all repeaters to a normal condition and reset the fault. For more information,
refer to RF Devices, page 78.
Reset the fault.
The FAULT indicator is turned off when there is no other system fault.
Restore all keyfobs to a normal condition and reset the fault. For more information, refer
to RF Devices, page 78.
Installation Guide
Troubleshooting | en 145
2014.11 | 02 | F.01U.267.112