Pitney Bowes DM300c Operator's Manual page 177

Maintaining the Moistener (cont'd)
Removing the Moistener (DM300c) (continued)
5. Clean the moistener brush by running the it under plain water.
Blot the excess water from the brush after rinsing it.
Replace the assembly if it cannot be cleaned thoroughly.
NOTE:
i
6. Position the brush as shown below so its bottom edge is under
the mounting tabs.
7. Slide the brush back toward the rear of the moistener.
8. If you need to clean the shield and wick, continue with Remov-
ing the Shield and Wick procedure on the next page. Otherwise,
push down on the blue re lease lever on the moistener.
9. Slide the moistener back onto the machine. You should hear a
click as it engages.
SV62261 Rev. C
12 • Maintenance
Release Lever
12-13