H/W Initial Information Setting Tool - Toshiba Portege M200 Maintenance Manual

3 Tests and Diagnostics
Use the up and down arrow keys to move the cursor to "ERROR STOP".
Use the right and left arrow keys to move the cursor to the option to execute and press Enter.
Selecting YES in ERROR STOP stops the test program when an error is occurred and displays
the error status. The operation guide will appear on the right side of the display as shown below:
ERROR STATUS NAME
Press [1]
Press [2]
Press [3]
Selecting NO in ERROR STOP displays the error status and increases error counter by one if an
error is occurred, and executes the next step.
The sections on and after 3.5 detail the tests of the DIAGNOSTIC TEST MENU. Refer to
Sections 3.21 through 3.26 for detailed information on the remaining Service Program Module
functions.
Table 3-1 in section 3.4 describes the function of each test on the subtest menu. Table 3-4 in
section 3.19 describes the error codes and error status for each error.

3.2.2 H/W initial information setting tool

The following menu appears in the display.
##################################################################
##
#### H/W initial information setting tool
####
##################################################################
##
* 1 ............
*
* 5 ............
*
* 8 ............
* 9 ............
*
******************************************************************
*
3-6
[[ HALT OPERATION ]]
Terminates the test program and returns to the subtest menu.
Executes the next test.
Restarts the test from the error.
Initial configuration
Digitizer FM write
System configuration display
E2PROM test (MAC/DMI)
3.2 Executing the Diagnostic Test
1: Test end
2: Continue
3: Retry
Portege M200 Maintenance Manual (960-457)
VX.XX
*