Toshiba Portege M200 Maintenance Manual page 213

4 Replacement Procedures
Installing the MDC modem
The following describes the procedure for installing an MDC modem. (See Figure 4-14 to
4-15.)
1. Connect the MDC modem cable to the MDC modem.
2. Connect the MDC modem to the connector PJ3020 on the system board and
secure it with the following screws
•
3. After turning up the insulator, arrange the MDC modem cable and connect to the
connector PJ3021 on the system board. Stick the glass tape.
Caution: When installing the MDC modem cable, make sure the cable does not cover
screw holes and is caught by the Fan.
PJ3021
Run the cable through the
two holes of the insulator.
Make sure that the cable
passes over the fin pipe.
Run the cable between the
MDC modem and mini PCI.
4-24
M2×4Z BIND screw
Lightly pull the cable not to give the
looseness on the MDC modem side.
Figure 4-15 Installing the MDC Modem
4.10 MDC modem
x2
Run the cable outside of the stud
screw of the CPU hold plate.
Lightly pull the cable not to give the
looseness on the MDC modem side.
Portege M200 Maintenance Manual (960 -457)