Bluetooth Test - Toshiba Portege M200 Maintenance Manual

3.16 Bluetooth Test

3.16 Bluetooth Test
To execute the Bluetooth Test, use the Test Diagnostics disk (Bluetooth). Finish the tests of the
Diagnostics disk (T&D) by selecting 99 - EXIT TO DIAGNOSTICS MENU in the
DIAGNOSTIC TEST MENU. Then in the DIAGNOSTICS MENU, select 9 - EXIT TO MS-
DOS.
Insert the Test program disk (Bluetooth) in the floppy disk drive and turn on the power.
NICSPC73.EXE
Follow the steps below to perform the test program, NICSPC73.EXE. This Program checks the
BD_ADDR function. Refer to Section 2.16, Bluetooth Troubleshooting, for a detailed
description of the troubleshooting procedures for the Bluetooth.
1. Preparing the target machine for NICSPC73.EXE
(a) Insert a floppy disk containing the test program into the target machine and turn on
the target machine.
(b) Prompts are displayed as shown in figure 3-1, if it is the first time the program has
run.
----------------------------------------------------------------------------
-
Bluetooth Subsystem T&D for PCSE(BD_ADDR) VerX.XX Copyright (C) by TOSHIBA
Co.
----------------------------------------------------------------------------
-
Initializing ...
Portege M200 Maintenance Manual (960-457)
Figure 3-1 Initializing for NICSPC73.EXE
3 Tests and Diagnostics
3-37