Toshiba Portege M200 Maintenance Manual page 177

3.26 SETUP
(*1) The FDD is looked for when the boot disk is contained in the external FDD.
When an SD memory card is set as the boot disk, the external FDD is looked for
first. Next, the SD memory card is looked for.
(*2) The HDDs are looked for in the order specified in "HDD Priority".
(*3) The CD-ROM is available only with the optional optical disk drive.
(b) HDD Priority
Use this option to set the priority for booting the computer from the HDD.
Built-in HDD -> PC Card
PC Card -> Built-in HDD
(c) Network Boot Protocol
Use this option to set the starting method via a network.
PXE
RPL Sets to RPL protocol.
7. Display
This group of options configures the computer's display.
(a) Power On Display
This option is used to select the display when booting up.
Auto-Selected
LCD+Analog RGB Selects both the internal LCD and the external CRT for
System LCD only Selects the internal monitor even if the external LCD is
NOTE: When LCD+Analog RGB is selected while connecting the external display
not corresponding to SVGA mode, no image appears on the display.
(b) LCD Display Stretch
LCD Display Stretch enables or disables a larger display area of the screen.
Portege M200 Maintenance Manual (960-457)
Sets to PXE protocol. (Default)
Selects an external monitor if one is connected. Otherwise it
selects the internal LCD. (Default)
simultaneous display.
connected.
The computer will look for the built-in HDD first,
next the PC card. (Default)
The computer will look for the PC card first, next
the built-in HDD.
3 Tests and Diagnostics
3-75